| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNC Machining Centers Discuss wood cutting CNC machining centers, and Point-to-Point machines here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-30-2009, 11:12 AM
| |||
| |||
Greetings I have a CNC machine "FANUC 5T SYSTEM. in which the electronics not working, I would like to redesign a two axis CNC control, using the engines to the machine is. I would appreciate as I suggest to begin the study of this project. Thanks    |
|
#2
08-30-2009, 11:19 AM
| ||||
| ||||
| Depends what your budget is, if you want to use the same motors and they are the larger Fanuc/Getty's DC motors, you may not be able to integrate the existing drives, so you need to locate large driver replacements. For larger motors, if using a control system that uses analogue signal such as Galil/Camsoft, then Advanced Motion Have them. If you use step/dir system such as Mach, then you may have a problem finding drives, You could also look at open system such as EMC, I believe there is a motion card you can use analogue drive signal with these. Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
