| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNC Machining Centers Discuss wood cutting CNC machining centers, and Point-to-Point machines here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-24-2009, 06:24 PM
| |||
| |||
I have a mitsubishi Frreqrol mod fr-se 7.5. The Freqrol manual says the orient requires a + -10 volt signal to make the orient function work. There is a magnet on the spindle and a detection sensor and an amplifier before the wires go to the controller. I am having trouble finding a new sensor. We mechanically broke ours. It has the key word macome and lbo and c1730. The magnet I use is c1730-06 The preamp is c1730-01. The entire kit is available from mits for $1400.00 What are other people using for spindle orient? Any ideas on how I can use newer cheaper components with the freqrol? Does anyone have these parts? Bob __________________ Robert Setree 502-452-9851
__________________ Robert Setree 502-452-9851  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hall Effect Chopper | legomanww | General Electronics Discussion | 5 | 12-20-2007 02:11 AM |
| Hall Effect Limit & Zero | Trebleplink | General Electronics Discussion | 3 | 10-19-2007 06:08 PM |
| Spindle Orient problem at Tool change | chipsahoy | Fadal | 5 | 12-18-2006 08:33 AM |
| Effect of T0 (tool offset cancel) | HuFlungDung | CamSoft Products | 5 | 09-01-2006 03:58 PM |
| Spindle will not orient at tool change | chipsahoy | Fadal | 4 | 07-16-2006 08:39 PM |
| | |
Linear Mode
