CNCzone Network: RFQwork :: 3Dstuffzone :: Welderzone
suggest a unit
I need to be able to engrave and cut complex holes in 3mm aluminum panels for standard 19" rack mouned electronic equipment.
I almost bought a taig mill, but the table is just too small. Is there an inexpensive, small-ish unit on the market that might work for me?
I like this one on ebay, but dont like that it used a dremel tool as the cutter. (I have burned up at least two dremel's in my life using as a hand tool)
Is there another option for a spindel setup?
By bcromwell in forum Phase Converters
Last Post: 04-21-2007, 12:11 AM
By cncuser1 in forum Xylotex
Last Post: 05-02-2006, 08:57 PM
By disinformation in forum General CNC (Mill and Lathe) Control Software (NC)
Last Post: 01-13-2006, 05:16 AM
By leewinn in forum General Metal Working Machines
Last Post: 11-22-2005, 12:53 AM
By CNCadmin in forum CNC Wire Foam Cutter Machines
Last Post: 04-07-2004, 12:23 AM