MasterCAM X post processor

[rodzilla]

I am having trouble getting a post processor file that works with MasterCAM X. I created a part using this but when i cut it the holes came out fine but the profile di not it cut the outter edge of the part way to close to the hole leaving not enough material to make it usefull. But when i created the same part using Visual Mill 5 i had no trouble the part cut fine is there a usefull post processor for MasterCamX to use with Mach3 could someone please help me with this problem

[billystein]

i would be happy to help you out. if you can send me your current post I will start to fix it for you. a few try outs should do it. I have done plenty of posts.


billy

[sdopp]

Are you sure your cutter comp was set right in X?
Skip