Acroloc Series 100 - CNCzone.com-The Largest Machinist Community on the net!

dr9487 · #1 06-21-2006, 02:27 PM

Can anyone give me any specifications including weight on an Acroloc Series 100 machining center? Thanks
Rick

little bubba · #2 06-24-2006, 11:41 PM

I hope you need the weight to tell some poor sole who is buying it how much it weighs(scrap man perhaps?). I would suggest finding the biggest piece of low weight crap machine you can find for the travels (not familiar with series) and subtracting about 30%.

Just for the record, I'm not completely down on Acrolocs, they were a pioneer, and for their time had some fantastic machines. The one we had was a piece of crap and we had to give it away, nobody would buy it.

dr9487 · #3 06-25-2006, 08:45 AM

I found the weight is 8500 lbs. This is one of their newer machines with the Fanuc controls.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)