Pendulum Problem

[bmelt]

I'm operating a Northwood with two tables and a GE Fanuc control and can't figure out how to get the machine to run two different programs in a pendulum operation. Is there something I should be doing to the G code? I can send the programs to the machine but, it wont run them. It gets to the end of the first program and stops, when I push start it will run the first program. I have tried deleting the % sign at the end of the first program.Here is the end of the first and the start of the next program I want to run on a different table
G8P0
M98 P8001 (END)
M02
%

START
%
:0001
(CREATED 30 JUN 11)
(NorthwoodFanuc_XPost_IW)
(CREATED BY JH)
(ANC9B5)
(T3 D0.5 .5 UP AND DOWN SHEAR)
M98 P8000 (START)
M98 P8201 (Y TABLE)