Contact Arturo, and let him know that his website is messed up, and you need a manual.
Bought new c62 recently - getting to setup and all the wonderful manuals error 404.
Anyhow, setting up c62 board with KL2283 drives. Possible to identify which wires from rj45 out goes to dir- / dir + / pul - / pul +? Thanks
Similar Threads:
Contact Arturo, and let him know that his website is messed up, and you need a manual.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Finallly got in touch with them via their site - they helped and they will.
The idea is that you connect that driver using the C34KL:
https://cnc4pc.com/c34kl-driver-to-r...s-drivers.html
If you do not have it, you could connect it using the pinout on page 15 of the manual of the C62:
http://cnc4pc.com/Tech_Docs/C62R5_USER_MANUAL.pdf
Connect PUL- and DIR- to GND and STEP and DIR pulsed on the C62 to PUL+ and DIR+.
I am sorry for the manuals folder in our website, it is OK now.
Arturo Duncan
Welcome to CNC4PC
The idea is that you connect that driver using the C34KL:
Wish I had known that existed before now. Dang.
Thanks for response - cnc4pc support has always been helpful. Glad site / manuals are back up
Edit - just ordered 3 of your adapters. should make install look nice as well as perform. Great idea. Consider making adapter like that for common VFDs?
Last edited by SchortBus; 08-09-2017 at 01:42 PM.
As FYI - received adapters today, the C34KL does not fit the KL2283 driver. Pins are too wide, does not match the inputs. Figure it would be same for the 1180 model.