EMERGENCY STOP AND 5V POWER SUPPLY
I have a RED and BLACK wire coming from the Emergency Stop, as well as a RED and BLACK wire coming from the small AC Power Supply in the box. Where do these 4 wires go?
__________________________________________________ ___________________________________
DB9 CONNECTOR MARKED “INPUT” ON CASE
Now for the plug that is really confusing me…. There is a DB9 Plug coming from the rear of the case. It has 5 wires that need homes on the C10 board.
PIN 1- BLACK
PIN 2- BLUE
PIN 3- BLUE
PIN 4- BLUE
PIN 5- BLUE
All of these wires need a home.
On the DB9 Connector PIN 6 is BLACK and PIN 7 is RED, and both run to the PWM SPEED CONTROL BOARD “ANALOG OUTPUTS” GND and 0-10V connectors.
It seems from looking at my mill that the original builder had the DB9 set up to be assigned for the limiting switches? There’s a smaller board on the back of the mill. I can get a picture of this if it helps?
__________________________________________________ __________________________________________________ __________________________________________________ ____________
ANY help is appreciated here guys. I really need to get this up and running.
I’ve got a PC setup with Linux to run it, as well as my mouse, keyboard, monitor ready to go. All that’s left as far as fabrication of parts is to get the mount for the monitor and stuff done and attached to the housing. Once I get it running the other parts that I wanted to modify are things that I am way more familiar with. This wiring part is totally foreign to me though. Sorry if this is all very stupid, elementary questions.
Thanks!