- Need Help!- Mach 3 WITH ESS C62 BOB AND DYN4
-
Registered
Mach 3 WITH ESS C62 BOB AND DYN4
I have the Estop to work on mach3 cant get DYN4 SERVO TO WORK
I install a jumper wire on the C62 ESTOP PORT
24 VOLT TO POWER THE C62 BOB AND THE ESS
I AM NOT SURE FOR THE CONFIGURATION JUMPER TERMINALS ON THE C62 BOB
I AM NOT SURE FOR THE PORTS AND PIN IN MACH3
ANY HELP WOULD BE APPRECIATES
THANKS
Similar Threads:
-
-
Registered
Re: Mach 3 WITH ESS C62 BOB AND DYN4
any luck figuring this out? im in the same boat with a C62, uccnc 300 Ethernet , and dyna 4 drives and motors...documentation almost non existent.
-
Registered
Re: Mach 3 WITH ESS C62 BOB AND DYN4
it working with the help of cnc4pc
what is your problem ?
mach3 or mach4
i could send you some picture of my set up
-
Registered
Re: Mach 3 WITH ESS C62 BOB AND DYN4
im trying to set up uccnc
-
Registered
-
Registered
-
Registered
-
Registered
-
Member
Re: Mach 3 WITH ESS C62 BOB AND DYN4
you should only have 5v to the c62 and ess.
-
Registered
Re: Mach 3 WITH ESS C62 BOB AND DYN4
thanks for your replies and pictures. cnc4pc sending me a few things to get me going.... im also using uccnc so my operation system is different.
-
Registered
Re: Mach 3 WITH ESS C62 BOB AND DYN4
are you happy with your set up? any issues?
-
Registered
Re: Mach 3 WITH ESS C62 BOB AND DYN4
VERY HAPPY WITH THE SET UP
-
Registered
Re: Mach 3 WITH ESS C62 BOB AND DYN4
What part of Canada you from? I'm 15 minutes from Cornwall, Ontario.
- Need Help!- Mach 3 WITH ESS C62 BOB AND DYN4
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules