Can’t Get Probe to Work with C10 BOB
The attached image shows how my probe is connected. Clicking on the Mach3 Auto Zero button, the tool is going up by 2” and then it stops and nothing else happens. Normally the tool should go down, touch the plate and then go up
The script I use is very basic but I have use it before and does the job, all I want is to set the Z axis height.
Message( "Auto Zeroing..." )
If IsSuchSignal (22) Then
code "G31 Z-2 F20"
While IsMoving()
Wend
Call SetDRO( 2, .125 )
code "G1 Z1"
End If
Any ideas what’s wrong?
Similar Threads:
Nicolas
Reply with Quote
