cncrp pro 48x96 and acrylic


Results 1 to 3 of 3

Thread: cncrp pro 48x96 and acrylic

  1. #1
    Registered
    Join Date
    Aug 2016
    Location
    United States
    Posts
    3
    Downloads
    0
    Uploads
    0

    Default cncrp pro 48x96 and acrylic

    Hello all, I was wondering if any of you had a good experience cutting acrylic with the cncrp PRO 4x8 or 5x10. More specifically are the cuts clean enough to solvent weld cleanly right off the table?

    Thanks in advance for any information you can provide.

    Similar Threads:


  2. #2
    Registered
    Join Date
    Apr 2013
    Location
    usa
    Posts
    56
    Downloads
    0
    Uploads
    0

    Default Re: cncrp pro 48x96 and acrylic

    1/4" single flute up cut, .125 DOC, 100 IPM, 8000-1000 RPM gives me a perfect cut



  3. #3
    Registered
    Join Date
    Aug 2016
    Location
    United States
    Posts
    3
    Downloads
    0
    Uploads
    0

    Default Re: cncrp pro 48x96 and acrylic

    Thanks for the response and for including your feeds/speeds. The next time you cut some acrylic do you think you could post a pic of the edge quality?. I guess I should have asked for that in the original post haha....



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

cncrp pro 48x96 and acrylic

cncrp pro 48x96 and acrylic