In Mach3, go into the Ports and Pins page and see which pins are assigned to each motor.
Then see if they match what your PMDX-134 setup.
Is there any documentation using the cncrouterparts XML config file what Smoothstepper/PMDX126/PMDX134 motor port mapping is? New to Mach 3. Machine is built and itching to plug the motors in put really worried about getting the Y slave motor in the wrong PMDX134 port. None of the schematics on the site have of the current detail about the slave axis. Any one have a DIY kit were they had to figure this out?
Thanks,
Steve
Similar Threads:
- Mach 3 5056 drivers Nemaha 23 motors. C20 BOB ..Issues tuning motors.. any help is t
- 3 Ametek motors with encoders * if you want these motors, you MUST bid on E Bay - No Longer Available
- servo motors or stepper motors for ATC machine
- RESOLVED! Mach3 MaxNC enabled = 1/4 speed motors , Disabled = no running motors.
- Just IN- Provide controllers,drives,servo motors,stepper motors,electronic parts from China
In Mach3, go into the Ports and Pins page and see which pins are assigned to each motor.
Then see if they match what your PMDX-134 setup.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Looking at the board, they're clearly marked axis 1, 2, 3, and 4
thanks for replies, the key was starting with crp300 xml file(pmdx126 based) for mach3 not crp800 file which is tailored to cncrp own breakout board.