Sorry about the PM issue I had.
I've never used that bit, but I think there info is incorrect. I'd try 200-250ipm at 13,000 rpm, but it's just a guess.
Good evening all,
I recently purchased one of these bits to try out on resurfacing my spoilboard. I was wondering if anyone could give me some recommended feeds/speeds on this thing for mdf?
I found this chart on Amana tool.
https://www.amanatool.com/pub/media/...1470408200.pdf
How many "flutes" is this thing considered to have?
Thanks for the help everyone
Similar Threads:
Sorry about the PM issue I had.
I've never used that bit, but I think there info is incorrect. I'd try 200-250ipm at 13,000 rpm, but it's just a guess.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)