Tighten the collet more?
Trying for the first time to router some 1/8" aluminum on my CNC router I built. Using Mach3 for g-code.
When routing the aluminum it will go fine for about 5 inches then the z axis will move downward when its cutting. I am using an upcut bit.
Any suggestions?
thanks
Similar Threads:
Tighten the collet more?
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)