Verify the COM on the PC and CN.
Verify the file Xilog3.ini if the settings is COM correct and it is working correctly.
The Old Computer that uses Windows 98 died. then I start to migrate to Windows XP.
First is the Xilog3 I have the backup of complete folders
Seccond the Kvara I have the backup of complete folders
Then I start a clean setup of Windows XP.
I did the configuration to make Windows XP to behave as monoprocessor OS
Install the Drivers
Everything OK til now...
I upload the files to
When I try to Open the BaseMenu this Message Appears.
Attach 1
And Xilog as it shows on Attach 2
Need Help, I try everything... Serial Ports are Working Flawlessly as Serial Cable has been tested with sucess...
I apreciate any help....
Similar Threads:
Verify the COM on the PC and CN.
Verify the file Xilog3.ini if the settings is COM correct and it is working correctly.
I have already check it for many times... it has the same configuration as it was in the old computer.
Try modify xilog3.ini.
Put ; in the third line and delete ; of the second line.
Because I remember the baud rate correct is 9600
I think I found the error, there's a file, params.cfg, I couldn`t copy that file, it say that file is corrupt...
that's the only thing is different between one folder to other...
Last edited by betancour; 01-18-2017 at 07:33 PM.
Try to set to only one cpu core In msconfig( google it )
Other thing could be com cable. Pin 2 and 3 must be switched in win xp.
I`ve made everything that people recommend to do
But still I can not make it work in Windows XP, I wonder if it`s possible to make a Win9X VM, and make it work with standart Virtualized Serial PORT.
I apreciate the help
Kindest Regards
Open the KVARA.ini file in the KVARA folder
Dears,
The same problem, can´t run the Xilog3 on XP or on higher WIN. Betancour have you solved it?