Walter HMC 500

[hugo_bpi_hc]

Hi,


I hope I'm in the right forum... I got a Walter HMC 500 and I have the next issue... My partner has replaced the CMOS battery of the MAIN CPU and the configuration of the BIOS has lost, we tried to start the MAIN CPU BIOS setup but we don't know how... Anyone can help us?


Thanks in advance

Similar Threads:

• Walter CNC Grinders
• Walter Grinder
• Need Help!- How do you resharpen a tap using the Walter hmc 500?
• Build Thread- WANTED USED WALTER HMC 400
• walter GC8

[omarms]

Hi Hugo, do you can start the MAIN CPU bios ?? How do you do ??

Regards

[Miller6386]

I know this is an old thread but I want to see if anyone has any information on a similar issue.... We are getting a CMOS RAM does not exist fault... I am assuming this is similar to a typical RAM card but I do not know which... I also need options to repair this or reflash what needs to be done... Any input will be greatly appreciated.

[omarms]

I know this is an old thread but I want to see if anyone has any information on a similar issue.... We are getting a CMOS RAM does not exist fault... I am assuming this is similar to a typical RAM card but I do not know which... I also need options to repair this or reflash what needs to be done... Any input will be greatly appreciated.

Hi Miller i can comment what we do when we have te problem:
May be you need to take some pictures from BIOS Setup
1st We discconect the cpu boards and clean the pins with an eraser and inset it again
2nd change the date in the bios and y DOS we use a date in 1996 (we have a 2YK)
Check Disk with scandisk and try

I hope this will help you

[Miller6386]

Hi Miller i can comment what we do when we have te problem:
May be you need to take some pictures from BIOS Setup
1st We discconect the cpu boards and clean the pins with an eraser and inset it again
2nd change the date in the bios and y DOS we use a date in 1996 (we have a 2YK)
Check Disk with scandisk and try

I hope this will help you

Can you elaborate on how to get into the bios.... looks like what I'm assuming my date is on the start up screen is reading 8:11:19159

Sent from my SM-N950U using Tapatalk

[omarms]

Can you elaborate on how to get into the bios.... looks like what I'm assuming my date is on the start up screen is reading 8:11:19159

Sent from my SM-N950U using Tapatalk

Hi; if you want to enter in BIOS only press the DEL key a cuple of times after turning on; and thats all; then find the date option; someting like this




Regards

[Miller6386]

Hi; if you want to enter in BIOS only press the DEL key a cuple of times and thats all; then find the date option; someting like this




Regards

Thank you very much... I actually found what I believe to be the card where the info is stored and the battery is dead. I am trying to locate a replacement board or a battery I can solder in and then re load missing information.

Sent from my SM-N950U using Tapatalk