- 8020 inc. T-Slot table construction
-
Registered
8020 inc. T-Slot table construction
I',m considering to setup a table for my cnc machine using 8020 inc. t-slot extrusions (15 series). Is that strong enough for holding and cutting 1/2" aluminum? I'll appreciate your response. Thank you
Similar Threads:
-
-
Community Moderator
Perhaps had you asked your question in the T-Slot forum rather than in the Classifieds Help forum, you might get an answer that would help you out.
Mark
- 8020 inc. T-Slot table construction
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules