need help Arrow 500 FNC control - CNCzone.com-The Largest Machinist Community on the net!

02-08-2009, 10:56 AM

gronux

Join Date: Feb 2009

Location: France

Posts: 1

need help Arrow 500 FNC control

permalink

I need help for arrow 500 with FNC control: i can have the setup of the control and can access to parameters, but how to communicate with the control with the RS232 , and how to upload program with a floppy disk
tks for response
Laurent

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ARROW 500 help	Lefty1961	Cincinnati CNC	3	11-11-2010 07:42 PM
Arrow 750 Failed to start when I Push start Bottom in fornt of control !	mte.jalal	Cincinnati CNC	4	01-06-2009 11:20 AM
Offline control unit from a cincinnati Arrow	Jimthefish	Cincinnati CNC	5	10-23-2008 09:59 PM
Arrow 750 - Only 40 volts going to my control power supply	laka	Cincinnati CNC	4	10-03-2008 10:23 PM
Cincinniti Milacron-arrow 750 Control Card	camay	Servo Motors and Drives	2	05-14-2008 07:33 PM

All times are GMT -5. The time now is 06:35 PM.