set up offsets

[gabby1]

hi how do you use offsets on hawk A2100 lathe ive been changing the geometry. Many thanks gabby

[KLUCAS4]

For Fixture offsets it should be H1, H2, H3 and so forth. for the acramatic control. On Fanuc this is g54, g55, g56 and so forth. To be honest I am not sure with this control for a lathe but, On a mill with this same control it should be h1, h2, and so forth. H1 1st part h2 2nd part.

[gabby1]

I shall try this and let you know many thanks

[laka]

You can adjust the wear offsets in the tool listing