Floppy Drive - CNCzone.com-The Largest Machinist Community on the net!

advt001 · #1 09-16-2008, 06:27 PM

Has anyone found a floppy drive for the 2100's without buying the outrageous priced part from Cincinnati or Siemens.Thank you.

CHAD LAWSON · #2 09-30-2008, 02:01 PM

i would try any computer store where they service computers. If you can not find one i have had to take one nown good one and use it in several machines as needed.

cncatj · #3 10-02-2008, 12:21 AM

Adv001
This is the same model of drive that is mounted in our machines Arrow 750

http://www.pcuniverse.com/Teac-Flopp...29/pd/p3649962

advt001 · #4 10-06-2008, 09:01 PM

Thanks for the link.Have you tried using one?Do you know what the board on top of the drive is for?

cncatj · #5 10-11-2008, 10:35 PM

advt001:
The board on top floppy drive is jus a 5VDC power supply

I haven't try one of this , the one i had as a back up it's exactly the same part number.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- DNC from floppy drive	jwknow	Haas Mills	5	03-11-2010 09:39 AM
Need Help!- Software vs floppy drive	jstucken	Haas Mills	7	05-28-2008 09:34 AM
Foolin around with an old floppy drive	compuslave	Stepper Motors and Drives	9	12-15-2007 11:17 AM
Yasnac floppy drive	dewcnc	Machine Problems, Solutions , Wireless DNC, serial port	0	03-19-2007 01:19 PM
Converting from Floppy Drive to USB	TZ250	General Metal Working Machines	3	09-06-2006 01:55 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)