Acramatic 850SX: memory board MMC was cleared

[guhl]

does anyone know how to force the control to work after memory clearing by means of disconnecting the batteries and shorting supercapacitor. I enter MTB commissioning data, but they don't get saved after power the machine on.
and I wonder what legend MTB INTF means (service mode). on other same machine I don't see it.
I had to clear the memory, because it didn't work: control were hanging up during loading
may there is a standard procedure, like in Fanuc controls?

[dj_pigs]

Hi, did you get this to work? I have same problem.

[guhl]

we've managed to make backup of memory board from another same machine and load it to cleared memory board
do you have the same machine?

[dj_pigs]

yes I have a talon 210 850 sx, it did have a dead battery, I replaced the battery, now I can input sys data and mtb data, but it will lose mtb data when turned off. can not start machine without mtb data.

[guhl]

my machine is talon 210 too.
PM sent