System Commissioning Data - CNCzone.com-The Largest Machinist Community on the net!

CPfef · #1 04-20-2011, 09:03 AM

We have a Cincinnati Milacron Horizontal machine with Acramatic 850 control.
It's a old retrofit machine. I want to change the built in R-plane amount of .1 that is at the machine. I believe it can be changed in the System Commissioning Data page. Does anyone have a list of what the numbers represent? #15 is set at .1 right now, but I am not sure this is it....

CPfef · #2 04-21-2011, 09:18 AM

I have figured out that #117 is controlling the R-PLane. It was set at .1000.
The reasoning behind this is. When I would send a program to the machine with a r-plane of .1, the machine was actually at .200. So, you would have to allow for this or program with a r-plane of 0.00. Which I feel is not a good practice.

Ron P · #3 05-15-2011, 05:50 PM

Don't have commissioning data anymore, but it was always standard practice for Acramatics to use R0 for the plane (corresponding to Z0) with the 0.100" handled by the CNC. Not bad practice, just different from Fanuc and others...and probably predates them. It's pretty clearly spelled out in the manual, but I imagine those might have been lost.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
SRAM backup VS System data save	fomaz	Fanuc	9	05-02-2012 03:26 PM
INSTRUCTIONS FOR STORING, HANDLING AND COMMISSIONING OF CAST IRON SURFACE PLATE	jashprecision	General Metalwork Discussion	0	08-19-2010 11:47 PM
Tool Data Management System	Kennebec	General Business Practices and Pricing	11	07-28-2010 12:49 PM
data downloading pc to cnc problem in 0MC/0MD fanuc system	vk_rathi	General Metalwork Discussion	1	04-07-2009 06:40 AM
system takes more time to display the data	karanindia	Fanuc	0	01-25-2007 01:30 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)