A2100 ALARM 39-73

[mmckell]

it's been 7 long months of waiting for "purse string holders", repair companies and couriers but, i was finally able to throw the power to our Arrow 500

had Mike Kilroy hooked remotely to check settings on the BDS5 - he say's ALL GOOD
did the align thing and tried a spindle command and got this error

ALARM 39-73
RUNOFF PATCHES INCORRECTLY SET
Cause – The runoff patches are incorrectly set for the action you require
Remedy – TOOL CHANGER set-up runoff patch required to operate the tool changer setup function
SPINDLE SET-UP runoff patches required to operate the spindle alignment setup on machines with high torque spindles
The machine will not be allowed to cycle while this patch is active

Severity – 70 Still in cycle – Cycle start blocked

any ideas what this might be?

thanks in advance folks
Mac

[mallardfizz]

hello it would appear that the run-off patches are set on.
press MORE
press SYSTEM CONFIGURATION
press MACHINE APPLICATION ( just above middle left hand side )
use the right arrow to move along untill you see a tab labelled RUNOFF.
None of the boxes should have a tick in them. if there is remove the tick. commit the changes and that should be it.
the security level should be set at service or above to make any changes.
for security
press MORE
press SYSTEM CONFIGURATION
press SECURITY (top left)
type in SERVICE then commit changes.
any questions please e-mail
regards
mallardfizz

[mmckell]

Originally Posted by mallardfizz hello it would appear that the run-off patches are set on. press MORE press SYSTEM CONFIGURATION press MACHINE APPLICATION ( just above middle left hand side ) use the right arrow to move along untill you see a tab labelled RUNOFF. None of the boxes should have a tick in them. if there is remove the tick. commit the changes and that should be it. the security level should be set at service or above to make any changes. for security press MORE press SYSTEM CONFIGURATION press SECURITY (top left) type in SERVICE then commit changes. any questions please e-mail regards mallardfizz

YOU ARE STILL THE MAN MALLARDFIZZ!!
that did it - i had a check in the spindle set-up box - my spindle now rotates

thanks a bunch
Mac

[mike_Kilroy]

EXCELLENT!

As usual, way to go Mallardfiz!