Need little HELP! With Arrow 750

[mike9a]

Hi all,

I've changed PSR5/4 on machine and during the pull out I 'yanked' one wire that was connected to C2 connector on VSF5 /spindle drive/I cannot find any schematic /looked all over the net/. Where that wire marked #424 needs to be connected?! Please take a look at the pictures and if you can just quickly open back of your machine panel and just look where that wire suppose to go.

I am getting the error on pic#2! may not be just wire!

I would appreciate any suggestion, direction or HELP!
Feel free to email me at: miked @ 9aic . com

Thank you,
Mike

[mallardfizz]

hello what electrical drawing number is your machine wired to?
its the bottom number on the silver label on the outside of the electric cabinet door. it will be 9120****
regards
mallardfizz

[mike_Kilroy]

is cnc back up? I wrote a bunchj last nite but it wud not go.......

[mike_Kilroy]

k, guess its back. email me at sales-at-KilroyWasHere.com and I will send u the manuals on your vfs5 & drives if u want. I wrote last nite the 2100 is saying it is missing the no fault sig from vf5s prob - the loose wire. drive up (no fault) is pins 16&17 IIRC from last nite look up. starts pin 1 on top left, dwn to 10 then 11 top right down to 20. if u want to wait till i get to office 8am to send u manual to be sure of pin nos that would prob be good idea.

[mike_Kilroy]

just to confirm. yes, it is 16 & 17; the missing wire goes in 17, just below the one in 16 and to the right of the lower red wire on the left.

[mike9a]

Hi mallardfizz,

There are two numbers under diagram:
91202971
91202949

Please if you do have those documents feel free to email me at:
miked @ 9aic . com
I would appreciate any document(s) I can get for Arrow750, just in the case!

I did solve it
Curtis @ak-builder.com sent me link to:
https://commerce.cinmach.com/default.htm

I called them and 30min later I was up and running!!
(wire 424 goes to pin 9 on C2 connector on VSF5)

C2
==
20 1
19 2
18 3
17 4
16 5
15 6
14 7
13 8
12 9<-424
11 10


As I told him, I did not even know there is an active cinc. support out there!
I was on my own all this time!


Thank you all for the quick and great help!

Mike
e-cnc.com
e-nesting.com
rhino3d.e-cnc.com

[scudzuki]

Agreed, Cincinnati tech support is alive and well at MAG. Mechanical parts are stocked and technicians are answering the phone! No spares for CT controls, though.

Mike Kilroy's Chris P spent a lot of time on the phone with me, too. Class act.

Joe