Cincinnati A2100 problems!!!!!!!!!!

[rai]

I just bought a used cincinnati vmc equipped with A2100. Presently I am looking for a DNC cable details, as I want to run this machine on DNC mode. I am facing following problems too:

-- As this machine set for INCH units, I want to switch machine cordinates INCH to mm. Some body send me details for the same.
-- Machine floppy drive is not working?
-- Is it possible to add a hard disk or zip drive to increase space?
-- How do I interface this machine on network/ lan?
-- DNC cable details?
-- Installation and maintenace manuals?
-- etc.
As I am not familier with this control (Acramatic 2100), kindly help me please.

[rai]

I am still waiting for somebody's help.............., Kindly help me please.

[Mr Bonavita]

Go to this site :
http://www.cinmac.com/Parts/PAcramat...PA2100Doc.html
It could be a good start.

[vbolhov]

Where to find a similar site for control of Hejdenhain 360?
Victor.

[nolly]

Please ignore previous message. It should read as follows:
Command G71 in your program will switch your machine to metric measurements. Command G70 to switch back to imperial.

Sorry for gaffe