4th axis rotary table - CNCzone.com-The Largest Machinist Community on the net!

PinnacleMachine · #1 06-17-2010, 11:26 AM

I have an Arrow 750 w/A2100 controller that is prewired for a 4 axis can I add any rotary table or do I need one with a Kollmorgan motor?

Thanks
JP

laka · #2 06-18-2010, 12:07 PM

Pretty sure you will need to match up the correct motor so the drive can deal with it. But not sure

These machines came standard with Troyke rotary tables that were re-branded as Cinci.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to install 4th Axis Rotary table?	MACKAY9999	Mazak, Mitsubishi, Mazatrol	16	04-28-2011 03:47 AM
DIY 4th Axis Rotary Table	Cartierusm	General Metal Working Machines	9	06-19-2009 10:22 PM
Rotary table or 4th axis	mikemill	Syil Products	3	05-13-2009 03:47 AM
Rotary Table as 4th Axis (setup help)	fc911c	Mach Mill	5	04-03-2009 10:08 AM
Newbie- Rotary table 4th axis set up	usfwalden	Knee Vertical Mills	2	05-05-2008 01:39 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)