adjustable angle milling head. - CNCzone.com-The Largest Machinist Community on the net!

Beek · #1 04-26-2010, 08:00 PM

I'm looking for one of these for a 630 horizontal. Does anyone currently use one? Looking for recommendations. I will need to do ATC with it. Milling / drilling holes in aluminum castings ~8mm thick.

Thanks

CNCRim · #2 04-26-2010, 11:52 PM

I think it's too expensive and the unit too heavy, eventually it's will take toll on servo, bigger spindle head for better rigid.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Adjustable angle live tooling for Multiplex 6300Y	TommyK	Mazak, Mitsubishi, Mazatrol	3	02-20-2010 11:06 AM
IBAG Adjustable Right Angle HS Spindles	wardcomm	Product Announcements & Manufacturer News	3	08-05-2009 10:46 AM
right Angle Head help	inkydo69	Mastercam	11	04-08-2009 09:58 AM
Programming An Alberti Adjustable Head	renglish	Daewoo/Doosan	1	09-01-2006 02:19 PM
Programming for angle head--G18/G19	Dave L	GibbsCAM	3	07-20-2006 10:33 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)