Arrow 500 Chiller - Need a bleed or startup procedure - CNCzone.com-The Largest Machinist Community on the net!

03-25-2010, 09:21 AM

Larry Callahan Larry Callahan is offline

Join Date: Jun 2007

Location: U.S.A.

Posts: 49

Larry Callahan is on a distinguished road

Arrow 500 Chiller - Need a bleed or startup procedure

permalink

We recently purchased an Arrow 500 that has a spindle chiller from a member on this forum. We have several other 500's without them so I am familiar with everything else. I would assume there is a way to bleed or prime the circulating pump? We don't have a book on it and I am about ready to put power to the machine.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Bleed board hold down Vac Motor	bhdavis1cnc	DIY-CNC Router Table Machines	2	03-16-2010 06:04 PM
Bleed resistor	appicnc	General Electronics Discussion	24	02-17-2009 07:26 AM
bleed resisitor	cueshark	General Electronics Discussion	17	12-06-2007 12:37 PM
bleed resistor	bobleecnc	General Electronics Discussion	11	04-30-2007 06:56 PM
Bleed down resistors for capacitors	garagefela	General Electronics Discussion	12	07-17-2004 08:40 AM

All times are GMT -5. The time now is 12:05 PM.