BDS4 overcurrent


Results 1 to 2 of 2

Thread: BDS4 overcurrent

  1. #1
    Registered
    Join Date
    Apr 2015
    Location
    Norway
    Posts
    22
    Downloads
    0
    Uploads
    0

    Default BDS4 overcurrent

    Hello,

    The Z-axis drive in my '95 Arrow 750 is throwing an overcurrent alarm.

    I have, in steps, disconnected the motor, replaced the two capacitors on the output and replaced the igbt module.

    Still it claims 'overcurrent'.

    Is there anything else I should take a look at? Software reset possibilities?

    Any hints are much appreciated.


    Regards







    Similar Threads:


  2. #2
    Registered
    Join Date
    Apr 2015
    Location
    Norway
    Posts
    22
    Downloads
    0
    Uploads
    0

    Default Re: BDS4 overcurrent

    I have found a simplified scheme tor the unit - could it be that the current limit pot is acting up?

    BDS4 overcurrent-bds4-jpg



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

BDS4 overcurrent
BDS4 overcurrent