tool changer drifting back

[coop31]

Hey guys,

My tool changer on my older Arrow 750 with a2100 control is acting up. The air cylinder pushes the tool changer to the spindle, but as soon as it gets there the air pressure is shut off and the changer is drifting back towards the parked position. Any ideas what might be causing this. I'm assuming something electrical. I've checked my other machines and the air pressure defiantly stays on at spindle position.

Similar Threads:

• Haas Tool Changer making honking noise at end of tool change
• Sprutcam 8 tool selection reverting back to default tool
• Johnford sv-45h tool change arm drifting after coming home
• Interact 412 - Tool Changer Not Back
• side mount tool changer-I take back what I said about

[coop31]

figured it out...Linear tracking tool drum was selected.

Hey guys,

My tool changer on my older Arrow 750 with a2100 control is acting up. The air cylinder pushes the tool changer to the spindle, but as soon as it gets there the air pressure is shut off and the changer is drifting back towards the parked position. Any ideas what might be causing this. I'm assuming something electrical. I've checked my other machines and the air pressure defiantly stays on at spindle position.