| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Cimatron Discuss Cimatron software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-02-2007, 05:59 PM
| |||
| |||
| Templates / Autodrill Any of you guys get in to depth with the use of templates? Would you be willing to share ideas on how you use them, how in depth you have went with it. I am looking for ideas about creating drafting templates that would make mold design faster. The 3-d isn't so bad but the 2-d stuff will wear a guy out. I have a strong background in NC, I tend to use alot of templates. Has anyone started using autodrill to create code for holes? I have played with it a few times, but since we have most of our base work done outside we don't drill that many holes. Danny    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Templates in UG NX5 (or 4) | Cammotion | General CAM Discussion | 3 | 11-02-2007 01:17 AM |
| digitizing 2d templates? | shadybacon | Digitizing and Laser Digitizing | 5 | 01-09-2006 11:19 AM |
| Anyone mill templates for castings? | studysession | General Jewelry Design Software | 5 | 12-05-2005 04:08 PM |
| How do I digitise some templates | Moondog | DIY-CNC Router Table Machines | 15 | 02-18-2005 07:38 PM |
| | |
Linear Mode
