Futai Talent Inverters for Spindle Control

[HobbyCAD]

Has anybody got any English info on how to operate the Futai or Talent inverters? The website used to have an English operating manual, but before I decided to download it, the site went down.

The controller unit came as part of a J-Cut 1836 router, supposingly to be operated with NC Studio software. The controller is therefore set in remote operation mode, waiting for a PC command to start it up. I want to return it to manual mode, to be able to operate it via the front panel keypad.

I have the Chinese manual, but that does not help me a lot. Not too many Chinese speaking engineering folk in my town. No use asking a Chinese doctor or restaurant owner, they don't understand the technical lingo !!

Thanks.

[Alexis_Wge]

I am in desperate need of one as well- Ours simply stopped working today- just flashes F and the frequency. It won't start, but it will jog, which is almost more frustrating because that means it still works. I assume it must have a fault of some sort, but I have no idea how to reset it.

[HobbyCAD]

Alexis,

Is yours the same as per my photo's? If not, send me a picture of the front, I'll send you a correct manual. I have received a few different models, including the correct Futai one.

[Alexis_Wge]

Alexis,

Is yours the same as per my photo's? If not, send me a picture of the front, I'll send you a correct manual. I have received a few different models, including the correct Futai one.

Thanks for the quick response.

Here's a picture of mine- It started working again this morning, so there is definitely some intermittent fault. I'm actively pursing other avenues to find this manual, so if it comes up I'll post it here.

[Tom67]

Has anybody got any English info on how to operate the Futai or Talent inverters? The website used to have an English operating manual, but before I decided to download it, the site went down.

The controller unit came as part of a J-Cut 1836 router, supposingly to be operated with NC Studio software. The controller is therefore set in remote operation mode, waiting for a PC command to start it up. I want to return it to manual mode, to be able to operate it via the front panel keypad.

I have the Chinese manual, but that does not help me a lot. Not too many Chinese speaking engineering folk in my town. No use asking a Chinese doctor or restaurant owner, they don't understand the technical lingo !!

Thanks.

Hi,

Any chance you could forwardme have a copy, mine is identical to the picture?

Tom67