T0000 tool change macro. I think this may need tweaked to us in inch mode.

[mikejeffers9]

I have attached my tool change macro. Syntec 6MA. This works great in metric mode, but when changing to inch mode, I must insert code in the program to change the machine to metric mode immediately before the tool change and back to inch mode immediately after the tool change. I renamed the file with a .txt extension so that I could upload it to this site. I would like to modify this macro so that I don't have to modify my program, and also so that the tool change works at 100% rapid mode. Currently, the tool change runs at 50% rapids which slows things down quite a bit.

Similar Threads:

• Need help with Macro for checking tool length before tool change
• Newbie- tool change and measure tool lenght, macro?
• Fagor 8055TC tool change position in Cycle mode?
• need help wana make macro for getting tool change by giving tool pot no on vmc instea
• Help for tool change macro on OM VMC