I have a SXCNC 6040 CNC with a JP-3163b controller using CNC USB Controller software to run it. So far the machine is up and running, even with end triggers. Now I would like to be able to control the spindle direction and speed from my laptop but I am having a lot of trouble with this.
There is a guide for setting up the VFD which I have followed:
So I should connect my analogue 0-10V output to the VFD as shown in the video. My first problem is that if I measure the voltage on the analogue output of the JP-3163b whilst changing the spindle speed from the software it only changes from 5-6V. Also, if I set the spindle speed to 0 in the software the analogue output jumps to 6V (Maximum).
Same issue here with JP-3163b.
The 0-10V output pin gives 5.0 to 5.93V.
The inverter have a 10V, 5V and 20mA input.
First I think, the 5V input is PWM. But this not work.
Any ideas?
The JP-3163D controller does not work! it had many design flaws, and was thus removed from production. The company further deleted all known versions of the manual and removed it from their manifest. The dangerous overcurrent will, in the long run, destroy the motors when used.