Looking for assistance with... :PARTIALLY SOLVED! - Page 4


Page 4 of 4 FirstFirst 1234
Results 37 to 37 of 37

Thread: Looking for assistance with... :PARTIALLY SOLVED!

  1. #37
    Registered
    Join Date
    Dec 2016
    Location
    United States
    Posts
    25
    Downloads
    0
    Uploads
    0

    Default Re: Looking for assistance with... PARTIALLY SOLVED!

    At the moment all but my spindle is working. Every time i try to start my spindle it goes full power. on the VFD the 24000rpm spindle is controled by 400hz. Every Hz seems to modify 60 RPM if my math is right, and the VFD isint lying to me. I have set the VFD D032 setting to 1 which refers to computer controle, and switched the knob to pc as per the instructions. The PC does in fact turn the spindle on, However.. It ramps to full speed and gives me an error of "PWM bumped to minimum setting"
    Here are my current settings
    http://i.imgur.com/ZGxOksa.png


    The spindle does however work on manual.

    Last edited by Ergelbak; 03-21-2017 at 02:26 PM. Reason: Posted before i ment too without fulll detail


Page 4 of 4 FirstFirst 1234

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Looking for assistance with... :PARTIALLY SOLVED!
Looking for assistance with... :PARTIALLY SOLVED!