there are a few little things to watch out for during the install of the kit.
1. did you get any of the travel extension portions?
2. remove the cross support at the base of the z axis ways.
3.i would remove the little check ball oiler ports and drill and tap these for 1/8 npt ports then you can get some fittings and attach a one shot oiler.
4. i used 2 one shot oilers one from the screws and one for the ways.
5.ultimately the settings and documentation for the electrical side is what i found lacking, however, gene is great for support and so is this board. if you read through my posts and follow what i did and learn from my mistakes you'll have it figured out.
if you have any questions just ask and i'm sure you'll get a bunch of answers.