- Y axis Ballscrew nuts screws NEED tightening
-
Registered
Y axis Ballscrew nuts screws NEED tightening
My Y axis is sloppy and I found the screws that secure the ballscrew nut to the table are loose. I can get to the rear two that are right on the edge, Has anyone tightened all four?
My mill is on a stand, on a pan, so I can not just go from underneath and gain access to them. I could punch a hole in the pan to access them but it appears that the "front" two are under/behind the ball screw itself.
I am thinking to try and take the table off?
Any clue on my best way to tackle this?
Thanks
Tony
Similar Threads:
-
-
Registered
-
Registered
Re: Y axis Ballscrew nuts screws NEED tightening
I think this assy video might be what Im looking for to Disassemble it and tighten the two screws
This might help someone else down the road.
- Y axis Ballscrew nuts screws NEED tightening
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules