I lowered the price of the belt drive to $300 if anyone wants it.
Hi guys; I listed for sale the first belt drive I ever made for the IH mill. It is used and works fine.
It is a single speed internal drive with a rubber mounted motor plate to fit a 185TC.
I have a video or tow on youtube of the drive.
And a really quick shot from the outside.
The listing is for 30 days. I will take the best offer.
I can answer any questions at davedaxx1@yahoo.com
I can sell direct too.
Thanks Guys.
Dave
Similar Threads:
youtube videos of the G0704 under the name arizonavideo99
I lowered the price of the belt drive to $300 if anyone wants it.
youtube videos of the G0704 under the name arizonavideo99
Is this working with the original Lesson motor? What is swapped out and/or what is needed?
Thanks
The motor plate is for a 185TC motor. The motor needs a long shaft but the pulley takes a QC bushing so any motor shaft size is OK. The shaft does need to be about 2" or longer.
I can drill the plate to take any other motor face mounting. The 185TC is a big face so everything else is smaller.
I just dropped the price to $250.
The motor I used was a 3hp 3650 RPM. It worked fine. The pulley ratio is .9 to 1 under drive so a 1750 RPM is not the best unless you want about the same RPM as stock.
I could turn the high speed pulley down a bit if you want more speed. I need to check it for clearance.
youtube videos of the G0704 under the name arizonavideo99
PM inbound
Hi i tryed to pm you but it did not work. Is this still for sale?
I still have it.
contact me at davedaxx1@yahoo.com
youtube videos of the G0704 under the name arizonavideo99
I would have been all over this (The Gear noise is driving me nuts) All the Googling, I can not find that motor.
The single speed drive has been sold to a IH owner.
Thanks guys.
Dave
youtube videos of the G0704 under the name arizonavideo99