Polishing advice needed

[SScnc]

http://www.romanoff.com/store/media/...pcm_manual.pdf

Look at the last few pages.

Thanks for that link Jeff, very good information and drawings. I appreciate it !

Seems pretty high for a rough, non plated, non finished casting.

Yeah, I think so too. That was just for "bright on bright", They quoted 12 parts at ~$23.00 each. I know they need to make money but that just wont work for me as I would be a reseller.

Oh yeah, my vibratory polisher, as seen in the first post here, arrived yesterday. I need to get some of the media that you guys have recommended and try it out.

[SScnc]

I have all the steel and motor, controls and flange bearings and I'm almost ready to actually start the machine build, as soon as I finish up another project this week. I've also been reading and researching everything I can find on this subject so I'll have a starting point to begin actually using it and refining my methods.

I'll start another thread on the machine with some pics. I do have another question I need some help with, who is a good supplier for the epoxy paint ?

I'm referring to the type of paint as seen being used on the medallions in the youtube video with syringes.

Thanks,

Steve

[jalessi]

Steve,

This is what most of the industry uses.


http://www.progresstool.com/search1....enamel&x=9&y=7


Jeff...

[Harryman]

Enamel paint too, thinned out a bit. Model paint works well. Left as is, or covered with clear epoxy.