| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Carken Products (Deskam, DeskCNC etc) Sub-Forums: Deskam, DeskCNC, DeskArt |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-17-2009, 12:27 AM
| |||
| |||
Could somone conected to DESKCNC please advise on support status. Is there a more sutable place to direct questions to? Having paid for the componenets it would be nice to know i'm not left to fend for myself. Please reply.  |
|
#2
12-17-2009, 06:54 AM
| |||
| |||
| Hi Rooboy, I am not connected to Deskcnc in any way other than I use it to run my router and I use the cam portion for all my machines. I will try to hep if I can. I have only had to contact them once and I just sent an email through the Deskcnc web site. Karl was very responsive and was open to the suggestion that I made. One thing I did find out is that the cam portion is windows shortcut compliant in that the ctr/x/c/v work for cu,t copy, and paste when working with G-code. These shortcuts don't appear when you right click. Let me know if I can help out in any other way. Mike
__________________ Warning: DIY CNC may cause extreme hair loss due to you pulling your hair out. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Support. | Jens H | Automation Technology Products | 21 | 09-30-2009 08:51 AM |
| Problem- no support | ljd10 | Carken Products (Deskam, DeskCNC etc) | 3 | 09-30-2009 02:27 AM |
| Support | Brendan | Milltronics | 1 | 03-17-2008 09:31 AM |
| Need Help!- PC CAM support | tengo8 | Bridgeport and Hardinge Mills | 1 | 03-03-2008 06:25 PM |
| APT Support | cimlinc | General CNC (Mill and Lathe) Control Software (NC) | 0 | 10-24-2006 12:01 PM |
| | |
Linear Mode
