| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Carken Products (Deskam, DeskCNC etc) Sub-Forums: Deskam, DeskCNC, DeskArt |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-09-2009, 09:16 AM
| |||
| |||
Need Z-homing script, everytime I try to home the Z it goes past the aluminum sensor!!!! Need a script to automatically make the z go up .325" after contact with aluminum surface. I'm using an aligator clip on the bit and the other end of the sensor is attached to a piece of aluminum angle on the work surface to home the z. Thanks in advance. Anton.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Newbie- Run G-code from script | leif_brunosson | LinuxCNC (formerly EMC2) | 1 | 11-11-2008 01:39 PM |
| Need help with VB script Syntax Please. | Adamj12b | Mach Software (ArtSoft software) | 6 | 09-18-2008 07:18 AM |
| Newbie- VB6,VB.net,VB script,What one??? | hydrospin01 | Visual Basic | 11 | 05-24-2008 08:09 PM |
| Engraving Script | id 10 t | Rhino 3D | 0 | 07-06-2006 11:17 PM |
| Macro/script-can this be done? | Splint | Rhino 3D | 3 | 02-12-2006 09:50 PM |
| | |
Linear Mode
