| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Carken Products (Deskam, DeskCNC etc) Sub-Forums: Deskam, DeskCNC, DeskArt |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-06-2008, 09:46 PM
| |||
| |||
I have powered up the controller and then opened up the software. and I get controller not detected. I tried to go in and change the com port and It doesn't reconize the com port, I went in and changed the machine setup for the table size and saved it, still does not see the controller. I have the motors locking and all 3 drives have the red lights on. The control board has the blinking light so it seems that the hardware side is working just no controller. Please HeLPPPPPPP!     |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| V2XT drive fault detected | DF-ENTERPRISES | Bridgeport and Hardinge Mills | 5 | 03-28-2010 09:10 PM |
| O-i controller? | Rich 72 | Fanuc | 4 | 12-04-2007 01:51 PM |
| V2XT error message "DRIVE FAULT detected (0,z,y,x) check log" | rfdoyle | Bridgeport and Hardinge Mills | 4 | 10-08-2007 04:35 PM |
| DeskCNC 2nd. gen controller AND HobbyCNC Pro Controller | maycom | DeskCNC Controller Board | 1 | 06-02-2007 02:33 PM |
| hardeware pause pause detected????? | Conquest1224 | Commercial CNC Wood Routers | 1 | 05-07-2007 11:06 PM |
| | |
Linear Mode
