| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Carken Products (Deskam, DeskCNC etc) Sub-Forums: Deskam, DeskCNC, DeskArt |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-24-2003, 02:26 PM
| ||||
| ||||
I am looking for anyone who is using the DeskWinNC software with the interface board that uses the PC's com port instead of the LPT port. Does the software work well under Windows? Does the software require special posts or will post for fanuc controller work fine? Any opionions would be great!
__________________ Thanks Jeff Davis (HomeCNC) http://www.homecnc.info (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)    |
|
#2
03-24-2003, 02:54 PM
| ||||
| ||||
| I used the non widows version, I like it very much, I stopped using it because it did'nt have constant vector contoring. The win version looks really good.
__________________ Thank You, Paul G Site Owner-Webmaster- Administrator www.rfqwork.com www.cnczone.com www.welderzone.com |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mach2 Vs DeskwinNC | whynot | General CAM Discussion | 0 | 12-19-2003 02:00 PM |
| | |
Linear Mode
