| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Carken Products (Deskam, DeskCNC etc) Sub-Forums: Deskam, DeskCNC, DeskArt |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-22-2003, 01:53 PM
| |||
| |||
Hi Gang hope this isn't out of line but I need a post processor file for Deskam to run turbocnc I screwed mine up and I'm getting all kinds of garbage commands. So if anyone has a file I'd appreciate it. Thank you.....Jim Oh yes I'm using a 2 amp camtronics board to drive my steppers. Last edited by jimini; 09-22-2003 at 04:26 PM.    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Emco Compact 5 PC...have ???? | Double G | Mini Lathe | 42 | 08-22-2010 07:26 PM |
| Upgrading control hardware - Emco | eDudlik | General CNC (Mill and Lathe) Control Software (NC) | 21 | 12-08-2009 01:52 AM |
| Sheet Cam Post Processor | CNCRob | Post Processor Files | 1 | 05-19-2005 05:10 AM |
| post processor help | jrrhotrod | Post Processor Files | 8 | 01-14-2005 04:45 PM |
| Phillips CNC-432 post processor??? | marx911 | Post Processor Files | 0 | 12-03-2004 10:07 PM |
| | |
post processor 
Linear Mode
