| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Carken Products (Deskam, DeskCNC etc) Sub-Forums: Deskam, DeskCNC, DeskArt |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-25-2005, 12:29 AM
| |||
| |||
i have desknc for dos when i hit the h key all the axis start to go home my question is dose desknc home the x,y,and z axis in a certain direction? for example the x axis goes to the right.can i make it home in the oposite direction?or do i need to have my home switch on the right side of the x axis? thanks for any help    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Limit and home switches EMC and Mach2? | ESjaavik | LinuxCNC (formerly EMC2) | 4 | 09-29-2008 11:39 AM |
| How do you hook up limit and home switches? | CNCadmin | DeskCNC Controller Board | 6 | 09-23-2007 04:34 PM |
| mach2 home switches | kong | Mach Software (ArtSoft software) | 14 | 11-27-2004 09:09 AM |
| The relationship of limit switches to home switches. | MikeAber | General Electronics Discussion | 4 | 11-04-2004 02:28 PM |
| Limit switches and home switches | viktorcnc | TurboCNC | 2 | 08-03-2004 07:11 AM |
| | |
desknc for dos home switches 
Linear Mode
