PUMA400L question - CNCzone.com-The Largest Machinist Community on the net!

ming035 · #1 11-17-2009, 12:26 PM

I am operating PUMA400L, anyone know how to copy file to a pcmcia controler? PUMA400L is FANUC 21i-TB, anyone has manual? Please send me one. My email ming035@yahoo.com. Thank you!

underthetire · #2 11-17-2009, 01:08 PM

Change the comm port number in the setting page. 0=RS232, 4=PCMCIA port. Punch/read as normal.

FYI-Early i series controls needed a special Flash card. Later ones could use ATA, CF etc.

ming035 · #3 11-18-2009, 11:21 AM

The setting do not let me to change. When I input 4 to the I/O channel it said wrong code. How to change the channel?

ming035 · #4 11-20-2009, 02:21 PM

I knew how to do it. turn to MDI and then change the Parameter write to 1, then change the I/O channel to 4.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)