Ontario: Looking for local CNC start up help - CNCzone.com-The Largest Machinist Community on the net!

11-22-2011, 06:40 PM

ruftwinturbo ruftwinturbo is offline

Join Date: Feb 2009

Location: Canada

Posts: 1

Ontario: Looking for local CNC start up help

permalink

Hi,

just recently purchased a Lagunmatic 3516 CNC with a Dynapath CN and am looking for help on initial setup with the machine.

I would like someone with knowledge with this CNC/CN that can go over the machine with me and make sure it is setup correctly. I believe there are a few small issues with the CNC hitting over-run limits, etc.

Located in Toronto, ON.

Please email me for further contact info, PM's are not recommended as I am unable to check here often.

Email: bgboost (at) hotmail [(dot)] com

Regards,
Marco

Tags

dynapath, lagun

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Just IN- What would you want to see from your local MTD rep	DANTEATER	General Business Practices and Pricing	0	04-02-2011 01:52 PM
Local Variables?	TURNER	NCPlot G-Code editor / backplotter	2	03-03-2008 06:25 AM
Local Suppliers	jhudler	Suggestions for the CNCzone.com site.	0	11-17-2007 08:12 PM
Local variables	jorgehrr	G-Code Programing	4	02-19-2007 03:03 PM
G65 local variables help	FanukRC	G-Code Programing	7	07-25-2006 06:00 PM

All times are GMT -5. The time now is 05:26 PM.