LinkBack URL
About LinkBacks
post them and we'll look
| | |
could anyone one here look at some gcodes for me an tell me what might be wrong , or if it is fine .
i dont have a machine or mach 3 YET, but been testing on a mach3 demo .
doesnt work for me but looks right .... to mehaha .
when i write stuff im just guessing since i have no training.
any one ?
thanks
post them and we'll look
Gerry
Mach3 2010 Screenset
http://home.comcast.net/~cncwoodworker/2010.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
not sure how to delet a whole post ..
Last edited by jezx; 02-17-2011 at 04:10 PM.
this is an interesting site . after reading stuff for a few days i realize that no one likes to say any thing , an when they do it is just a general rough idea .
or they say ''contact the company/supplier''.
also very interesting that 40 people looked at this an no one can read gcode
..i know i am as ignorant as it get for cnc stuff , but thats sad
is my gcode so far off that no one knows what it is .. haha
It's one thing to ask for help if it doesn't work. But asking if it's right or wrong is another story. Just looking at you're code, it looks OK, but without knowing what it's supposed to do, and actually running it, it's hard to say for sure.
If you have the Mach3 demo, set it up, load your code, and run it. That's the best way to know if it's OK. If it doesn't work, tell us what doesn't work, and if there are error messages, and we'll be glad to help.
Not sure what you've been reading the last few days, but it diesn't sound anything like this site.
Gerry
Mach3 2010 Screenset
http://home.comcast.net/~cncwoodworker/2010.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
guess im done . i'll figure it out .
Last edited by jezx; 02-17-2011 at 04:08 PM.
Posting Permissions
| | |
