RFQ for 2 machined parts - CNCzone.com-The Largest Machinist Community on the net!

automationsteed · #1 01-07-2011, 11:07 PM

Hi everyone, I am looking at getting a few parts machined out of mild steel, I know its not a big order, might be well suited to a garage type outfit. These are for my new steel and alum router build. Please let me know what you would charge to machine 2 of the the parts in the drawing, shipped out to Edmonton Alberta.

Thanks,

Automationsteed

etjoe · #2 01-13-2011, 03:55 PM

Are you looking for these parts to be milled out of aluminum?

knopine · #3 06-12-2011, 08:23 AM

They can be made by the process of E.D.M Cutting or stamping,but stamping need the tool and 2 machining parts is not worthy.So E.D.M Cutting should be better.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
RFQ for 2 machined parts	automationsteed	Employment Opportunity	1	01-13-2011 07:48 AM
Newbie- Machined parts wanted...	speedyridge	General Metalwork Discussion	1	07-28-2009 07:16 AM
Machined parts	Dolphin USA	Dolphin CADCAM	3	02-01-2009 02:36 PM
Need A Quote- Need a few small machined parts	justhman	Employment Opportunity	4	04-21-2008 12:22 PM
Need parts Machined??	tizank	Employment Opportunity	32	10-24-2005 08:28 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)