1/8" End Mill in Toronto or Canada?

[tim_j]

I'm looking for some smaller (1/8" and smaller) two flute end mills. I'm looking to cut plastic, wood and aluminum...and maybe some PCB's. I'd also like to purchase locally.

Would anyone know where I can buy these? (without having to purchase in bulk).

Regards,
Tim

[ihavenofish]

kbctool in missisauga. atlas tools downtown on queen street.

thats where i get most of my stuff. if i need good carbide i order from amritool in the US. they are alot cheaper than KBC, and atlas has a fairly limited selection.

[rschieck]

http://www.leevalley.com/en/wood/pag...168,46171&ap=1


http://www.leevalley.com/en/wood/pag...168,46171&ap=1


hth

Rob

[steveg]

Try hard industrial supply www.tryhard.net
KBC tools www.kbctools.com/can
perhaps atlas machinery www.atlas-machinery.com

try your yellow pages for industrial or machine shop supplies

[tim_j]

Thanks for the suggestions. I will check them out. Ive tried lee valley however I require 1/8" shank diameter as well.

[nokillzone]

Nothing locat BUT!!

http://cgi.ebay.ca/1-8-1250-2-FLUTE-...item2305b8811c

But! Item US $3.75 Shipping US $5.95
Theres also a Single Flute for US $4.00

[forrey45]

Made in the GTA
Deboertool.
Forrey.

[Dropout]

BC Saw on Evans Ave in Toronto.

[frankee]

I purchase most my cutters from S.B. Simpson but I know for a fact that you can buy a 1/8 cutter (1/8 shank) from the Dremel section of any Home Depot.